(comes with your order)
1. Remove the silver cap, open the bottle by gently twisting the
lid off. At first the lid will be hard to remove but it will become
easier to open after some practice of opening it and frequent use.
The bottle will not leak when the silver cap is snuggly fitted on
the lid -- even when full of water and laid on its side.
2. Remove the mineral container from the small box in the right
hand side of you Alkalark box. Discard the plastic protective wrapping.
Rinse under cool water and shake off droplets.
3. In your left hand, tilt the bottle at about a 45° angle and
slide the mineral container into the bottle with the large holes
in the mineral container facing the top of the bottle and the three
small “feet” on the bottom of the mineral container
facing the bottom of the bottle. As the mineral container slides
to the bottom straighten up the bottle so it “seats”
itself into the bottle.
4. Remove the blue cleaning solution bottle from the right hand
side of the box, open it and put three (3) droppers full (as much
as you can get into one easy squeeze of the dropper top) into the
bottle directly onto the mineral container. Add enough bottled water
to barely cover the mineral container. Then shake the bottle from
side to side to thoroughly cleanse the minerals. Do this for 30
to 45 seconds, NO LONGER! Using the cleaning solution for more than
a minute can reduce the minerals’ life expectancy, so when
using the cleaning solution, keep in motion from start (cleaning
solution into the mineral container) until finished. Rinse with
tap or bottled water. While you are shaking and cleaning the bottle,
the water will turn a milky color. This indicates the minerals are
being cleaned. Discard the water.
5. Rinse the bottle and mineral container in the bottle thoroughly
with bottled water or tap water until the water in the bottle is
clear. When finished with the initial cleaning, the silver mineral
balls will be bright silver. Thus you have successfully cleaned
the mineral container.
6. Fill the Alkalark bottle to the rim with bottled or reverse osmosis
water. Place the lid and silver cap onto the bottle. In fifteen
(15) minutes the water will be ready to drink. It ONLY takes fifteen
(15) minutes after the initial cleaning and your weekly cleaning.
After that it only takes three (3) minutes for the minerals to make
alkaline reduced water – ready for you to drink until the
next cleaning session!
Be sure to read the Daily and Weekly Maintenance
instructions for proper care of your Alkalark set.
NOTICE
 1.
Use purified/bottled water when filling the bottle to drink. Unpurified
/tap water could decrease the life span of the minerals.
2. When the Alkalark is not going to be in use for more than a week,
separate the mineral container from the vessel. Wash and dry it.
This will ensure that it remains in its formerly new condition.
3. You will be able to see fine residue on the bottom of the vessel
when in use. The powder which is a blend of natural minerals is
harmless to the body. (Recommended - rinse it once a day and wipe
clean with a non-abrasive towel)
4. Sometimes after drinking, you may feel a need to frequently urinate.
This is a natural symptom. Alkaline reduced water returns our body
condition back to its normal state. As a result, drinking Alkalark
water will promote urination.
5. Clean the bottle using a soft sponge. Do not use abrasives. You
may wash your vessel and lid in the dishwasher. Remove the mineral
container.
6. Always use water under 100° F to clean.
|
Home